Vcarve Pro not giving Ready2Control bad data

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Steve W
Posts: 2
Joined: Mon Dec 27, 2021 2:47 pm

Vcarve Pro not giving Ready2Control bad data

Post by Steve W »

I am a newbie so this is most likely an operator error... I am using Vcarve Pro to create my projects but when I am carving text (saving tap file and loading it into the machine using Ready2Carve) the finished product comes out almost 1/2 the size of my job in Vcarve .. What am I doing wrong??

tonydude
Posts: 1581
Joined: Tue Aug 17, 2010 9:23 am
Location: Buffalo,NY

Re: Vcarve Pro not giving Ready2Control bad data

Post by tonydude »

Are you using the right post processor? CNCShark-USB Arcs (inch) (*.tap) and the other one is Next Wave CNC (inch) (*.tap) also are your job size in inches not mm

Tony
Buffalo,NY

"What will matter is not what you bought but what you built; not what you got, but what you gave”

Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.

Steve W
Posts: 2
Joined: Mon Dec 27, 2021 2:47 pm

Re: Vcarve Pro not giving Ready2Control bad data

Post by Steve W »

My bad, the new controller and pendant were set to the wrong model type.

Post Reply