I need some help with this. I am trying to get the post processor for the shark to use with cut 3d. I went to the nextwave automations download page and tried to download it from there. followed instructions and got a message saying it could not be downloaded. Does anyone have any solutions. I have emailed vectric and I am awaiting a reply.
peter
post processor for cut3d
Moderators: al wolford, sbk, Bob, Kayvon
Re: post processor for cut3d
I would try a different browser - right click on the link and select save as.
If you already have the correct post processor files (inches and mm) for use with VCarve, they are the same for Cut3D, just copy them over.
A useful post on post processor files in general is -http://www.cncsharktalk.com/viewtopic.php?f=10&t=109
If you already have the correct post processor files (inches and mm) for use with VCarve, they are the same for Cut3D, just copy them over.
A useful post on post processor files in general is -http://www.cncsharktalk.com/viewtopic.php?f=10&t=109