I've been cutting A LOT of HDPE lately, and I'm done sweeping. Here is a lightweight dust collector for the Shark Pro, in 1/4" King ColorCore. The brushes are from McMaster-Carr. You have to glue them into the grooves using cyanoacrylate glues. The hose is press-fit into the opening.
If I do anything else to the design, it will be to bring the hose closer to the router, to reduce the size. Right now, it can bump some of my taller clamps.
This is not a copy of the commercial product sold by Rockler. It is my own design, although undoubtedly it looks very similar. I mean, there's only so many ways you can skin a cat, right?
Free to use in any way you like.
Best,
Wildseyed
My Take on the Dust Collector
Moderators: al wolford, sbk, Bob, Kayvon
Forum rules
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
My Take on the Dust Collector
- Attachments
-
- Dust Collector.crv
- (129.5 KiB) Downloaded 639 times
-