Bob,
Sure let me organize them! I did them in Rhino and loaded them straight to the Shark cnc processor.
I'll try to upload them this week. There are 2 files (top & bottom) with 2 tools changes each.
Thanks again!
David
Bowling with Bob...
Moderators: al wolford, sbk, Bob, Kayvon
Forum rules
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Re: Bowling with Bob...
Thanks David,
I look forward to it.
Bob
I look forward to it.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)