Bowling with Bob...

[Bob]

The Bowl:

Here is the crv file for the bowl top:

bowl 11.25 long X 7 wide X 1.875 thick.crv

(1.38 MiB) Downloaded 1144 times

And, the bottom:

bowl bottom 11.25 long X 7 wide X 1.875 thick.crv

(3.21 MiB) Downloaded 1032 times

Have fun,
Bob

[tonydude]

Bob,

Thanks a lot for the files.

Tony

[jimbob45]

Thank you ever so much!!
I will be sure to post as soon as it is done. What a fine fella you are.
Cheers

[jimbob45]

Thank you ever so much!!
I will be sure to post as soon as it is done. What a fine fella you are.
Cheers

[Bob]

You're welcome. I would really like to see how your projects turn out.
Bob

[Wolffie1]

Thanks Bob
Hopefully I will get the machine up and running again soon.
Cheers
Wolffie

[BobA]

Thanks Bob,

I really appreciate your ideas, Willingness to share and your advice on using the Shark.

Thanks again,
Bob

[Jim Krager]

Very nice bowl. Thanks for the crv files.

[Bob]

You're welcome everyone.
Please be sure to run simulations before any actual cuts, and understand the cutting sequence. The first cut is very conservative with light passes. All other cuts are 5/16" deep because they are taking out very little wood. Just be sure that your bit can cut the full depth specified. Be ready on the big red button for the first few passes. After that, be sure to have reading material handy, or do other projects near by.
Bob

[BobA]

Thanks for the bowl program. I had to modify a little because I could only come up with 1.75 material.

BobA