This design has been requested for sharing. http://www.cncsharktalk.com/viewtopic.p ... 441#p22441
It's been three years since the original post. I probably found the right one:
Try air cuts first.
Let me know if it works...or doesn't.
Bob
Concentric Ring Bowl
Moderators: al wolford, sbk, Bob, Kayvon
Forum rules
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Concentric Ring Bowl
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)