Page 1 of 1
Does anyone have a file to cut out FIDGET SPINNERS?
Posted: Fri May 12, 2017 10:46 am
by jonathanmoczy
Looking for a file to cut out fidget spinners that are all the rage right now. My son really wants us to make one on the CNC. I am needing a file for a fidget spinner with 22mm bearings. Any help would be appreciated!
Re: Does anyone have a file to cut out FIDGET SPINNERS?
Posted: Fri May 12, 2017 12:54 pm
by Bob
Like this?
- spinner.crv
- six nickel spinner
- (295 KiB) Downloaded 578 times
Bob
Re: Does anyone have a file to cut out FIDGET SPINNERS?
Posted: Fri May 12, 2017 12:55 pm
by Bob
Here's one that's twice as good:
Bob
Re: Does anyone have a file to cut out FIDGET SPINNERS?
Posted: Fri May 12, 2017 12:57 pm
by Bob
This one's worth three dollars:
Bob
Re: Does anyone have a file to cut out FIDGET SPINNERS?
Posted: Fri May 12, 2017 12:59 pm
by Bob
Be sure to prepare the bearing by removing the side dust covers and all lubrication. Use them with no lubrication.
Bob
And remember, On all of these designs, your results may vary...
Re: Does anyone have a file to cut out FIDGET SPINNERS?
Posted: Fri May 12, 2017 1:05 pm
by Bob
And, How about this...The directions. Remember, your results may vary.
Bob
Is that enough information yet, Jonathan?
Re: Does anyone have a file to cut out FIDGET SPINNERS?
Posted: Sat May 13, 2017 10:46 am
by jonathanmoczy
Thank you Bob! Have not yet had a chance to check out your files but I will this evening. I really appreciate the response. I am just now learning this myself and made the attached file last night. It worked pretty good. Also, thanks for the tips on the bearings. I tried to epoxy them in place but it did not go so well..
Jonathan
Re: Does anyone have a file to cut out FIDGET SPINNERS?
Posted: Sat May 13, 2017 4:18 pm
by Bob
Jonathan,
You're welcome.
And, thanks for posting your crv!
Have fun and try not to make the experience too complicated.
Bob