Hello Everyone !
Moderators: al wolford, sbk, Bob, Kayvon
Forum rules
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Hello Everyone !
I'm new to the CNC Routing . Are There any files for kitchen cabinets doors and what not ..Or where would be a good place to look Thanks
Re: Hello Everyone !
From what I've heard, Etsy.com of all places. I am also pretty sure there's cabinet routing software out there....the first one I saw, though, was like $1700....ouch!
=====================================================
ThomR.com Creative tools and photographic art
A proud member of the Pacific Northwest CNC Club (now on Facebook)
ThomR.com Creative tools and photographic art
A proud member of the Pacific Northwest CNC Club (now on Facebook)
Re: Hello Everyone !
Check here:
https://forum.vectric.com/viewtopic.php ... t&start=75
No cost. It is being developed by a Vectric forum member.
Bob
https://forum.vectric.com/viewtopic.php ... t&start=75
No cost. It is being developed by a Vectric forum member.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: Hello Everyone !
Schweet! Thanks, Bob!Bob wrote: ↑Mon May 17, 2021 8:22 pmCheck here:
https://forum.vectric.com/viewtopic.php ... t&start=75
No cost. It is being developed by a Vectric forum member.
Bob
=====================================================
ThomR.com Creative tools and photographic art
A proud member of the Pacific Northwest CNC Club (now on Facebook)
ThomR.com Creative tools and photographic art
A proud member of the Pacific Northwest CNC Club (now on Facebook)