Dust Collection Hose Location
Moderators: al wolford, sbk, Bob, Kayvon
Dust Collection Hose Location
Does anyone have a good idea how to keep the dust collection hose elevated and out of the way while in use to prevent pinching or draging on the table? I have tried several different ways and they end poorly. If you do, please post a picture.....Thanks.
Re: Dust Collection Hose Location
I don't have a picture to share, but can tell you what I have done. I used the dust collection kit from a Craftsman system for my piping. This is smaller and the connector ends fit perfectly into the 2 1/4 inch opening of the dust collector. I suspended a rod from the ceiling down to approximately 4 foot above the CNC. I then fastened a long screen door spring onto the rod (make sure it is a weak tension spring) and secured that to the hose with a clamp. The hose moves very freely and is always vertical to the machine. A second section of the hose, which runs to the dust collector, is fastened with a long bungee cord to just keep it out of the way. It works great. Simple, but very effective. I believe this would also work for a 4" hose but haven't tried that. Hope this may help.
Iwejan
Iwejan
Re: Dust Collection Hose Location
Here is my setup-
Re: Dust Collection Hose Location
Thanks Jim, that gives me some ideas. How is the sleve on the side attached to the side of the arm?
Re: Dust Collection Hose Location
sleeve is aluminum flashing padded with foam. Side one is held on with 1/16" alum strap screwed to upright.
Top one is suspended by 1/8" alum strap
Jim
Top one is suspended by 1/8" alum strap
Jim
- NewAgent45
- Posts: 230
- Joined: Sun Sep 08, 2013 8:29 am
- Location: Edgewater, Florida, USA
Re: Dust Collection Hose Location
I don't have a picture handy but I keep it simple. I'm using 2 1/2 inch hose to connect to the dust boot connection and my vacuum system is overhead. I use an adequate length of flexible hose and some bungee cords connected overhead to take up the slack and some of the hose weight of the hose.
Have a great day!
.. Rod
Have a great day!
.. Rod