Page 2 of 2
Re: X and Y Axis
Posted: Tue Oct 29, 2019 4:16 pm
by Bob
There have been posts about the magical code: 787
Go here to unlock the potential.
Bob
https://www.cncsharktalk.com/search.php?keywords=787
Re: X and Y Axis
Posted: Tue Oct 29, 2019 4:33 pm
by Kayvon
sharkcutup wrote:Oh yes rotating design before creating toolpaths Would solve his Problem IF he had left the cables alone in the first place!!!
My mistake. I was looking at his second post (after messing with cables).
I agree. I just leave Y as the long axis and rotate my jobs to fit.
Re: X and Y Axis
Posted: Wed Oct 30, 2019 5:16 pm
by sharkcutup
The Two Major Reasons not to mess with the machine is
1.) machine may be in warranty and messing around with it may VOID said warranty.
2.) it could very well cause more problems than it could solve
Sharkcutup
Re: X and Y Axis
Posted: Thu Oct 31, 2019 6:46 pm
by Kayvon
You'll note that was my first suggestion as the first reply from 8 months ago.
Kayvon wrote:1) You can change the dimensions in software so that X is 16" and Y is 36". This is what I do. It may require rotating your design to fit in the corrected dimensions.