Page 1 of 1

ups battery backup & surge protector for Shark HD3

PostPosted: Sat Jun 29, 2019 10:32 am
by sharkcutup
Is there anyone out there who knows what the total Wattage of the Shark Pro Plus HD3 machine is? Also does anyone have any idea as to the wattage of the 2hp Spindle and Inverter (110V 13amp) Kit?

I am looking to put a UPS battery backup & surge protector on my total system (computer, shark CNC (stepper motors) & controller, 2hp spindle & Inverter and the cooling pump).

I need this because over time I have found that my home is on a block of the city with the weakest current link (example: neighbors across the street would have power & neighbors a block over from neighbors behind my house would have power, but my block would NOT have POWER. Power outages on clear sunny days!!! Need an efficient & safe way to shut down everything down when there is a power outage!

Thank Everyone!

Mike

Re: ups battery backup & surge protector for Shark HD3

PostPosted: Mon Jul 01, 2019 8:19 am
by WNC_Ed
Only observations I have made so far:
This is measured from the Tripp-Lite Smart 3000 UPS

Running a Pocket toolpath with .125 End Mill on Foam - 100IPM
Everything running - 120v:
Shark HD4
H2O Spindle 120V
H2O Pump
Led light - 12v 1Amp Transformer

The highest Wattage seen was 167 Watts

Thinking that if cutting more than foam it might be higher.

Edit - 12k RPM
When I increased RPM to 17k it jumped to 172 Watts
Roughly 1.5 Amps

Re: ups battery backup & surge protector for Shark HD3

PostPosted: Thu Jul 04, 2019 7:04 am
by sharkcutup
Thank you for the information WNC_Ed

Sharkcutup