X axis slop
Posted: Wed Oct 14, 2020 8:33 pm
I am getting about .020 slop in the carriage on the x axis. It is not from loose connector at the motor or loose screws. How does one adjust the drive nut system to take this slop out?
Could be the T-nuts are going.
Run through the tightening procedures mentioned in this thread to ensure you didn't overlook something.
http://www.cncsharktalk.com/viewtopic.php?f=15&t=3382
If that doesn't work, the end of the thread describes procuring new T-nuts. Good luck.