virtual zero unlimited

Discussion about the CNC Shark Pro Plus HD

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
gpeck
Posts: 181
Joined: Fri Sep 06, 2013 1:35 pm

virtual zero unlimited

Post by gpeck »

I understand there is a virtual unlimited that maps more than five points. Will it work on the black diamond HD3? for what I have read it is a free down load.

The virtual zero five point map does not come up on the controller. the touch plate reads that it has been detected when I touch the bit and stops when it detects the plate going down, but it will not move to detect any where else. I have not used it for sometime. Will I most likely need to reinstall and how would I go about that.... Thanks for any info.
Gene

Rando
Posts: 757
Joined: Tue Jan 06, 2015 3:24 pm
Location: Boise, ID
Contact:

Re: virtual zero unlimited

Post by Rando »

This is sheer conjecture, but you might need to be running their Ready2Control software as well?
Is the virtual zero an add-on to that?

The old control panel software definitely would not have the capability to do that.

sorry if that's of little help...

Rando
=====================================================
ThomR.com Creative tools and photographic art
A proud member of the Pacific Northwest CNC Club (now on Facebook)

gpeck
Posts: 181
Joined: Fri Sep 06, 2013 1:35 pm

Re: virtual zero unlimited

Post by gpeck »

I got the virtual zero when I got the black diamond HD3 in 2014. Is that too old?

gpeck
Posts: 181
Joined: Fri Sep 06, 2013 1:35 pm

Re: virtual zero unlimited

Post by gpeck »

I am running v10.512 and 2.1 on the controller. is that what Ready2Control software needs ?? thanks,, gene

Post Reply