Shark HD520 - Z Axis Dragging to Next Cut
Posted: Thu Dec 28, 2023 1:17 am
Hello all! Happy Holidays!
I have a new issue on my machine I am trying to correct. I have the Shark HD520 and when the machine is cutting - it will drag the bit through the piece as it raises the bit to the next location. Like, its jogging as the bit is raising out of work, creating a BEAUTIFUL sloped cut though my work!! It's really a pain in the rear and it doesn't happen on every cut or move, just 4 or 5 times and enough of an issue, the pieces are scrap. This is everything I have done so far: I have set the height at .5 (from .2), I have zeroed the touch plate on the piece of material cutting. I have slowed the cutting way down even to the point of setting it 5in/min just to see if maybe it's moving too fast before the Z axis catches up, and I have checked all the set screws in the lead screws on the machine itself. When I preview the 3D cut paths in the software (V-Carve Pro), it is clearly showing a clean cut, and shows the Z Axis raising to the .5 above the work piece before moving to the next letter/part of whatever it is to be cut. But this isn't happening in reality.
Any help or direction would be amazing!!!!! Would like to finish these Christmas presents, and well.. they are now going to be New Years presents!!
I have a new issue on my machine I am trying to correct. I have the Shark HD520 and when the machine is cutting - it will drag the bit through the piece as it raises the bit to the next location. Like, its jogging as the bit is raising out of work, creating a BEAUTIFUL sloped cut though my work!! It's really a pain in the rear and it doesn't happen on every cut or move, just 4 or 5 times and enough of an issue, the pieces are scrap. This is everything I have done so far: I have set the height at .5 (from .2), I have zeroed the touch plate on the piece of material cutting. I have slowed the cutting way down even to the point of setting it 5in/min just to see if maybe it's moving too fast before the Z axis catches up, and I have checked all the set screws in the lead screws on the machine itself. When I preview the 3D cut paths in the software (V-Carve Pro), it is clearly showing a clean cut, and shows the Z Axis raising to the .5 above the work piece before moving to the next letter/part of whatever it is to be cut. But this isn't happening in reality.
Any help or direction would be amazing!!!!! Would like to finish these Christmas presents, and well.. they are now going to be New Years presents!!