When the cutter is going down and close to table is makes a sound like a dry hinge.
Is there something that needs lubrication like the screw? Black Diamond. Otherwise
running good.
Squeak type noise on Z axis plunge
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: Squeak type noise on Z axis plunge
Yes, put some silicone lube on the screw and the shafts, jog it up and down a few times and the squeak should be gone.
Re: Squeak type noise on Z axis plunge
Is there any certain type? Spray or tube applicator. I have the pure silicone spray lube.
Re: Squeak type noise on Z axis plunge
Next Wave sells a spray brand on their web store. I just use one I found in Home Depot. They are all pretty much the same. Clean the threads and shafts with compressed air or vacuum to remove any dust. Use the aerosol can to spray the parts or spray on a rag and apply. Run it up and down a few times and reapply if the squeak is still there. The spray will leave a thin coating. Don't use a gel or grease type that will attract dust. You should do this on each axis frequency depending on usage.
Re: Squeak type noise on Z axis plunge
Thanks for the reply. Used the spray and squeak stopped. Now to see how long before it starts again.