I seemed to have lost my progress % and progress time on last update
of panel. anyone else? am I missing something?
thanks for any help
Jim
2.x panel
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: 2.x panel
Jim,
I just downloaded V2.1 Build 16 and both of the items that you mention are working correctly. It is better than I have seem it in earlier versions as there is no flicker in the screen update. Very nice!
I also checked out other previously observed issues and I don't see any issues. There are lots of very nice features. I see in the release notes that a Build 17 is proposed but I have never observed the problem that this build will address. I like the new grid line feature in the SCP build 16. I suggest that you update to this version if you are presently running some other build of SCP 2.x.
Great work, Joe, in case you read this post. I'm very pleased with the improvements.
Ed
I just downloaded V2.1 Build 16 and both of the items that you mention are working correctly. It is better than I have seem it in earlier versions as there is no flicker in the screen update. Very nice!
I also checked out other previously observed issues and I don't see any issues. There are lots of very nice features. I see in the release notes that a Build 17 is proposed but I have never observed the problem that this build will address. I like the new grid line feature in the SCP build 16. I suggest that you update to this version if you are presently running some other build of SCP 2.x.
Great work, Joe, in case you read this post. I'm very pleased with the improvements.
Ed
Re: 2.x panel
I found my problem. I am using a small Acer in the shop with a 10" screen.
I had the screen maxed- upper right corner- no info on bottom
with the screen semi maxed (?) it has the info I thought I lost
Operator error
I had the screen maxed- upper right corner- no info on bottom
with the screen semi maxed (?) it has the info I thought I lost
Operator error
Re: 2.x panel
If you update to the new build 16 and do not see the enable boxes for the Virtual set up and the A-Axis if you have it I had a similar problem and posted a fix for it here.
http://www.cncsharktalk.com/viewtopic.p ... 725#p24725
http://www.cncsharktalk.com/viewtopic.p ... 725#p24725