depth of cut

Anything and everything CNC-Shark-related

Moderators: ddw, al wolford, sbk

Post Reply
misterx
Posts: 35
Joined: Fri Apr 08, 2011 4:55 pm

depth of cut

Post by misterx »

Hi, I have a shark HD2 extended bed with a Bosch 1617 EVS router (2.25 HP) and want to do a 3d roughing cut with a .5" end mill. I was wondering what depth of cut I can use, I've never used a .5" end mill yet and wanted to know what you other people are using for depth of cut for that bit. I'm doing the cut in soft maple and just don't know how deep of a cut I should do. Thanks Tim

User avatar
Kayvon
Posts: 493
Joined: Tue Oct 21, 2014 11:46 pm

Re: depth of cut

Post by Kayvon »

I would do 1/4" cuts per layer, but that probably pretty conservative compared to what most people would use for pine.

Post Reply