Page 1 of 1

New Shark 2 axis cables not labeled

Posted: Mon May 06, 2019 12:18 am
by Whisperwild
I just got a Shark 2 and cannot find info or diagram showing the cable route. The Y cable from beneath the end of table is labeled... the Plastic sleeve wrapped X and Z cables are not... one DB connector sits at end of sleeve, and the other extends 6 inches beyond sleeve..with one RCA which I understand is ground. Can someone tell me which is which?

Re: New Shark 2 axis cables not labeled

Posted: Thu May 09, 2019 8:37 am
by OCEdesigns
You can call Nextwave but you can also just plug them in and see which is which. It won't hurt anything.

Re: New Shark 2 axis cables not labeled

Posted: Thu May 09, 2019 2:29 pm
by cbhelms
On my Shark, the cable with 2 wires with connectors; the short 1 goes to the Z connector and the other connector goes to the X connector. The Y wire is at the end of the table and it connects to the Y connector.
Hope this helps.

Colin Helms