New Shark 2 axis cables not labeled
Moderators: ddw, al wolford, sbk, Bob, Kayvon
-
- Posts: 1
- Joined: Sat Oct 06, 2018 12:10 am
New Shark 2 axis cables not labeled
I just got a Shark 2 and cannot find info or diagram showing the cable route. The Y cable from beneath the end of table is labeled... the Plastic sleeve wrapped X and Z cables are not... one DB connector sits at end of sleeve, and the other extends 6 inches beyond sleeve..with one RCA which I understand is ground. Can someone tell me which is which?
-
- Posts: 105
- Joined: Fri Jan 11, 2019 8:26 am
Re: New Shark 2 axis cables not labeled
You can call Nextwave but you can also just plug them in and see which is which. It won't hurt anything.
Shark HD4 Extended Bed, Water Cooled Spindle. VCarve Pro 10.5
Maker of many chips
Maker of many chips
Re: New Shark 2 axis cables not labeled
On my Shark, the cable with 2 wires with connectors; the short 1 goes to the Z connector and the other connector goes to the X connector. The Y wire is at the end of the table and it connects to the Y connector.
Hope this helps.
Colin Helms
Hope this helps.
Colin Helms
Shark HD 5 Extended Bed, Aspire 10.514