Page 1 of 1
Butt Impression Please
Posted: Mon May 27, 2019 6:26 pm
by bill z
I Figure on making some stools with butt impression seats (carved chair seats) but I do not have any ideas on dimensions (what is considered standard (is there such a thing?)).
Probably use VCarve, 3D carving and a round bull nose bit to do most of the work. Only guessing here.
Can't find any Youtube about Vetric and chair bottoms. I may check out how to do spoons and go from there.
Ideas and help please.
Re: Butt Impression Please
Posted: Sat Jun 15, 2019 8:52 am
by bill z
With nothing that I could find to go on, I started to draw something symmetric.
I'm still looking for suggestions here.
Figuring something like 24" wide, 20" deep on a 2" thick board but only cutting 1" deep, this is what I came up with. Interesting enough, I figure I'll have to carve it and try it out for me to know if it is even close.
Re: Butt Impression Please
Posted: Sat Jun 15, 2019 11:14 am
by sharkcutup
Something like this?
I have some tractor seat models at hogancnccrafts.com that might help.
Sharkcutup
Re: Butt Impression Please
Posted: Sun Jun 16, 2019 12:03 pm
by tonydude
Here you go just page down for the seats.
http://www.designsbyphil.com/3d-file-share.html
Tony
Re: Butt Impression Please
Posted: Sun Jun 16, 2019 4:12 pm
by bill z
sharkcutup wrote:Something like this?
Tractor Seat Model B.jpg
I have some tractor seat models at hogancnccrafts.com that might help.
Sharkcutup
Yes Sharkcutup. What are the dimensions? How wide, long and deep? The dimensions will really help me.
Thanks.
Re: Butt Impression Please
Posted: Mon Jun 17, 2019 7:55 am
by tonydude
hogancnccrafts.com, fake site, don't work
Tony
Re: Butt Impression Please
Posted: Mon Jun 17, 2019 7:58 am
by tonydude
Bill Z take a look here and download the files
http://www.designsbyphil.com/3d-file-share.html
Tony
Re: Butt Impression Please
Posted: Mon Jun 17, 2019 7:59 am
by sharkcutup
17" x 17" x 2.0"
Sharkcutup
Re: Butt Impression Please
Posted: Mon Jun 24, 2019 3:16 pm
by Kassim27