Page 1 of 1

Spindle--3/4 or 1/2 shank?

Posted: Tue Nov 05, 2019 3:34 pm
by MrsEmPeel
Does anyone know a way of fitting a 3/4" shank onto the water cooled spindle? Is there an adapter? Can you change out the piece that holds the collet? I just realized I can't even use a bit with a 1/2 inch shank. HELP!

Re: Spindle--3/4 or 1/2 shank?

Posted: Wed Nov 06, 2019 12:56 pm
by Kevink18
I installed a musel chuck I can go up to 1/2 in

Re: Spindle--3/4 or 1/2 shank?

Posted: Thu Nov 07, 2019 10:54 am
by sharkcutup
Kevink18 wrote:
I installed a musel chuck I can go up to 1/2 in
On an ER20 collet type spindle or an ER11 collet type spindle???

Sharkcutup

Re: Spindle--3/4 or 1/2 shank?

Posted: Fri Nov 08, 2019 8:48 pm
by Kevink18
ER 20

Re: Spindle--3/4 or 1/2 shank?

Posted: Fri Jul 01, 2022 1:04 pm
by RxDr
Do you think a muscle chuck that would accommodate a 1/2" shaft would work in a 2 HP ER11 spindle?

Re: Spindle--3/4 or 1/2 shank?

Posted: Wed Jul 06, 2022 9:48 am
by Rut Row
MrsEmPeel wrote:
Tue Nov 05, 2019 3:34 pm
Does anyone know a way of fitting a 3/4" shank onto the water cooled spindle? Is there an adapter? Can you change out the piece that holds the collet? I just realized I can't even use a bit with a 1/2 inch shank. HELP!
Buy a 1/2" ER20 collet