Router Stops mid job
Posted: Mon Mar 11, 2024 6:42 pm
I have had my Shark SD120 for a few weeks now and have completed many projects without issues. Today, the router stopped three times mid tool path on tool paths that had been successfully completed in previous days. I was able to complete the job by re-running the tool path after bypassing the router relay switch and manually starting the router and dust collection.
I read that this could be an issue of interference between the power cables and the data cable.
Has anyone had a similar issue? Should I take stepd to separate the data cable from the power cable? Is there another explantion?
I would like to continue to use the router relay as it is far more convenient than manually starting the router.
TIA.
I read that this could be an issue of interference between the power cables and the data cable.
Has anyone had a similar issue? Should I take stepd to separate the data cable from the power cable? Is there another explantion?
I would like to continue to use the router relay as it is far more convenient than manually starting the router.
TIA.