Greetings All,
I've just received my 4th axis kit and noticed that the center of the tailstock is 3/16" higher than the center of the head unit. I do a lot of turning and if my lathe tailstock was that far off, my pieces would be ruined. I have sent an email to NextWave but have not had any replies. Any suggestions?
Thanks,
Bob Pastor
Head/tailstock Alignment
Moderators: sbk, al wolford
-
balbritton
- Posts: 15
- Joined: Wed Apr 06, 2016 11:17 am
- Location: Holland, OH
Re: Head/tailstock Alignment
Hi Bob,
You may have an older tailstock with a new head unit or vice versa. Would you mind taking a picture of both and posting? We would know right away. Sorry for the inconvenience!
You may have an older tailstock with a new head unit or vice versa. Would you mind taking a picture of both and posting? We would know right away. Sorry for the inconvenience!
Brandon Albritton
Sales/Engineering - Next Wave Automation
Sales/Engineering - Next Wave Automation