Head/tailstock Alignment

Everything 4th Axis

Moderators: sbk, al wolford

Post Reply
bpastor
Posts: 4
Joined: Mon Jun 26, 2017 7:23 am

Head/tailstock Alignment

Post by bpastor »

Greetings All,

I've just received my 4th axis kit and noticed that the center of the tailstock is 3/16" higher than the center of the head unit. I do a lot of turning and if my lathe tailstock was that far off, my pieces would be ruined. I have sent an email to NextWave but have not had any replies. Any suggestions?

Thanks,
Bob Pastor

balbritton
Posts: 15
Joined: Wed Apr 06, 2016 11:17 am
Location: Holland, OH

Re: Head/tailstock Alignment

Post by balbritton »

Hi Bob,

You may have an older tailstock with a new head unit or vice versa. Would you mind taking a picture of both and posting? We would know right away. Sorry for the inconvenience!
Brandon Albritton
Sales/Engineering - Next Wave Automation

Post Reply