new to 4th axis
Posted: Sat Dec 22, 2018 2:10 pm
Hi Everyone,
As in my previous post I just got my new tool and I am working on getting to work. I have run into a few snags so far. I have been watching the videos that I can and reading everyone's experiences.
1. In the literature during the set up process it says to rotate the piece with the pendant. However at this point I still can not find the control to rotate it. I do have the Controller program I can run through my computer as well and no control comes up to rotate through there either. I am thinking somewhere even with Nextwave telling me that I have the right firmware and software something is not working right.
2. Does my stock have to be round or can I start with a block?
Last of course I am wondering if anyone would be willing to share a file or two that I can use to help my learning curve?
As in my previous post I just got my new tool and I am working on getting to work. I have run into a few snags so far. I have been watching the videos that I can and reading everyone's experiences.
1. In the literature during the set up process it says to rotate the piece with the pendant. However at this point I still can not find the control to rotate it. I do have the Controller program I can run through my computer as well and no control comes up to rotate through there either. I am thinking somewhere even with Nextwave telling me that I have the right firmware and software something is not working right.
2. Does my stock have to be round or can I start with a block?
Last of course I am wondering if anyone would be willing to share a file or two that I can use to help my learning curve?