Page 1 of 1

Help with lasering with 4th axis

PostPosted: Sat Dec 22, 2018 6:26 pm
by Superwrench
I have searched the forum, but come up empty. I am trying to laser engrave on a wooden travel mug using the 4th axis. If I use the laser PP, the gantry moves in the Y axis. If I use the rotary PP, the laser won't light up. What am I doing wrong? I am two weeks behind on this project for Christmas and feeling the pinch.

Re: Help with lasering with 4th axis

PostPosted: Sun Jan 06, 2019 3:52 pm
by Superwrench
I just realized this was a question for Vectric software, not just Shark related. I received an answer from Vectric that said "at this time, it is not possible to laser on the 4th axis". Bummer, that is one of the main reasons I bought this setup...