Does anybody have the settings or setup using aspire for carving 3D on Plexi?
I see some prefer both front and back side and I would like to try it on the backside.
Any help would be appreciated.
Thanks
Wayne
Setting for 3D Carve on backside of Plexi
Moderators: al wolford, sbk, Bob, Kayvon
Setting for 3D Carve on backside of Plexi
Aspire 8.024, photo vcarve, cnc Shark 60th, control panel 2.1
Re: Setting for 3D Carve on backside of Plexi
Always use cast acrylic when doing edge lit acrylics. Are you doing a real 3D carving or just a normal carving on plexi? I use either a .0625 ball nose bit or a 90 v bit or a diamond drag bit on acrylic. If your doing a 3D I use a tappered ball nose bit. The pic shows a 3D rose I did in 1/2" cast acrylic. Always use the backside when carving and reverse your carving and lettering. When using the front you will see shadows.
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.