I am cutting a 1/4 deep hole by 2 3/8 in aluminum with 1/4 router bit any recommendations on:
Cutting Parameters:
Feeds and Speeds:
Number of Passes:
Offset verses Raster:
Climb verses Conventional:[/list]
Thanks
Joe
Aluminum
Moderators: al wolford, sbk, Bob, Kayvon
Re: Aluminum
Joe,
The best advice I can give you is to contact Rando (Do a search). Thom is incredibly experienced with cutting aluminum. Also, if you search this forum, you will find lots of information on this subject.
Bob
The best advice I can give you is to contact Rando (Do a search). Thom is incredibly experienced with cutting aluminum. Also, if you search this forum, you will find lots of information on this subject.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)