Designs for Engraving
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 4
- Joined: Fri May 04, 2012 1:07 pm
Designs for Engraving
Is there any free designs that Shark owners can use on projects for engraving such as butterflies, animals, sports etc.
- NewAgent45
- Posts: 230
- Joined: Sun Sep 08, 2013 8:29 am
- Location: Edgewater, Florida, USA
Re: Designs for Engraving
Bmiestervs:
I'm assuming you are using Vectric Software (VCarve Pro or Aspire) I just upgraded from VCP 7.5 to VCP 8. With the upgrade there is a whole series (over 300) of "freebees" including Clip art & 3D models some of these are animals. I have already used several of these for projects.
I was able to get the upgraded software with no charge. If you are using there software you can check with Vectric to see if your are eligible for free or discounted upgrade. I found the upgrade easy to install without affecting the original version. Also found that the transition to the new version was simple.
Hope this helps!
.... Rod
I'm assuming you are using Vectric Software (VCarve Pro or Aspire) I just upgraded from VCP 7.5 to VCP 8. With the upgrade there is a whole series (over 300) of "freebees" including Clip art & 3D models some of these are animals. I have already used several of these for projects.
I was able to get the upgraded software with no charge. If you are using there software you can check with Vectric to see if your are eligible for free or discounted upgrade. I found the upgrade easy to install without affecting the original version. Also found that the transition to the new version was simple.
Hope this helps!
.... Rod
Re: Designs for Engraving
If your looking for clipart go to google and type in what your looking for, example butterfly line drawing or butterfly coloring pages. Thats how I get my clipart for a lot of my carvings.
Tony
Tony
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
-
- Posts: 584
- Joined: Sun Jan 15, 2012 6:46 pm
- Location: North Little Rock, Arkansas
Re: Designs for Engraving
I'm with Tony on this. I always Google line art after entering what your looking for. Just about any drawing can be used. If you need to clean it up a bit, I use GIMP. It's free, very powerful, and pretty easy to use. I also have a program on my iPhone that turns a regular photo into line art, called photosketch, and SketchFree. These two really work well, but usually needs cleaning up a bit.
Being retired is hard work. Spending way too much time in the shop these days. (And loving it).
Shark Pro Plus HD, Vcarve Pro, Photo V Carve, Cut 3D, scan probe.
Shark Pro Plus HD, Vcarve Pro, Photo V Carve, Cut 3D, scan probe.
Re: Designs for Engraving
BELOW IS A LINK TO A FACEBOOK GROUP THAT SHARE FILES.
https://www.facebook.com/groups/415833581934542/
https://www.facebook.com/groups/415833581934542/