drag knife

How-to videos on the CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
gpeck
Posts: 181
Joined: Fri Sep 06, 2013 1:35 pm

drag knife

Post by gpeck »

setting up the drag knife, do you set z at the table top or the material top?

User avatar
Kayvon
Posts: 552
Joined: Tue Oct 21, 2014 11:46 pm

Re: drag knife

Post by Kayvon »

You've posted this question in the Videos section of the forum. Probably not a good spot if you want a good answer.

Fortunately, you've had at least one response from the same question you asked on this thread here:
http://www.cncsharktalk.com/viewtopic.php?f=15&t=6406

Post Reply