How can I reset the Z zero without resetting the X and Y?
I am doing a 3D carving and I initially set the Z zero from the machine bed and don't want to remove the piece I am working on to reset the zero when I change bits.
I am using a Shark HD4 with Aspire software.
Thanks,
MD
Z zero question
Moderators: al wolford, sbk, Bob, Kayvon
Re: Z zero question
Yes, this can (and should) be done each time you change bits.
Are you using the Shark Control Panel? It's as easy as clicking "Z" in the upper-left corner.
Are you using the Shark Control Panel? It's as easy as clicking "Z" in the upper-left corner.
Re: Z zero question
Kayvon wrote:Yes, this can (and should) be done each time you change bits.
Are you using the Shark Control Panel? It's as easy as clicking "Z" in the upper-left corner.
Kayvon,
I am using the pendant for my controller.
Re: Z zero question
MD,
Since you're setting Z zero to the bed, you can move the gantry to an area of the bed that is not covered by your carving and set Z zero there.
But, don't reset the X or Y.
If I'm understanding your question correctly.
Bob
Since you're setting Z zero to the bed, you can move the gantry to an area of the bed that is not covered by your carving and set Z zero there.
But, don't reset the X or Y.
If I'm understanding your question correctly.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: Z zero question
Thanks guys, I did some investigating of the setting on the pendant and figured out how to change only the single axis.
I appreciate the help.
MD
I appreciate the help.
MD
-
- Posts: 105
- Joined: Fri Jan 11, 2019 8:26 am
Re: Z zero question
Glad you got it figured out!
Why are you using the bed for your Z zero? Just curious.
Why are you using the bed for your Z zero? Just curious.
Shark HD4 Extended Bed, Water Cooled Spindle. VCarve Pro 10.5
Maker of many chips
Maker of many chips
-
- Posts: 105
- Joined: Fri Jan 11, 2019 8:26 am
Re: Z zero question
Glad you got it figured out!
Why are you using the bed for your Z zero? Just curious.
Why are you using the bed for your Z zero? Just curious.
Shark HD4 Extended Bed, Water Cooled Spindle. VCarve Pro 10.5
Maker of many chips
Maker of many chips
Re: Z zero question
I also use the bed for my zero. I prefer doing this over choosing the top of material for zero because the material thickness may not perfectly match the design. By choosing the bed as zero, my spoil board lasts longer because I'm not milling into it very often.