Control box on hd plus doesn;t pass test

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
jimbob45
Posts: 50
Joined: Sat May 19, 2012 4:45 pm
Location: Pensacola Florida

Control box on hd plus doesn;t pass test

Post by jimbob45 »

I have just received my CNC Shark pro plus HD and it will not pass the first power up. The manual states that the blue light should come on and stay on. I get a steady red and the amber and blue lights flash on and off. It is the weekend so I can't contact Next Wave for help. Has anyone experienced this problem??

jeb2cav
Site Admin
Posts: 1524
Joined: Thu Sep 30, 2010 7:04 pm
Location: Kentucky
Contact:

Re: Control box on hd plus doesn;t pass test

Post by jeb2cav »

Good morning - I'd continue with setup and just see if it 'works'. There may have been a minor change in how the LEDs function, or a goof in the manual. Certainly after you power up and connect to the computer, the lighting should appear as described.

jimbob45
Posts: 50
Joined: Sat May 19, 2012 4:45 pm
Location: Pensacola Florida

Re: Control box on hd plus doesn;t pass test

Post by jimbob45 »

Thanks for the info Joe. It now passes the tests.

User avatar
shicks1015
Posts: 10
Joined: Wed Apr 25, 2012 11:05 am

Re: Control box on hd plus doesn;t pass test

Post by shicks1015 »

I had the same problem when I set mine up few weeks back. The blue light never came on but it runs fine. I posted this in an earlier thread if you want to search back.

Shawn

Post Reply