Page 3 of 3
Re: Clamping
Posted: Tue Aug 24, 2010 7:39 pm
by Bob
I have a dxf file of the clamp, I have just been unable to post it. Tell me how and I can save you a little work.
Bob
Re: Clamping
Posted: Wed Aug 25, 2010 8:11 am
by Bob
Kim has just informed me that dxf and crv files can now be uploaded. I tried again with no success. I just keep getting the message: The image file you tried to attach is invalid. I'll wait a little while and try again.
Bob
Re: Clamping
Posted: Wed Aug 25, 2010 12:57 pm
by Bob
OK,
It looks like this might work!
These files are for the cam clamp pictured earlier in this discussion.
Someone try it and let me know if it worked.
Bob
Re: Clamping
Posted: Wed Aug 25, 2010 1:06 pm
by Bob
wyzarddoc wrote:Could you post the DXF or shark files for the clamps since the weblink is broken?? Thanks
Doc
Hey Doc,
I think Kim fixed it!
When I opened the crv. file the toolpaths were included. Have fun!
Just try an air cut first and don't blame me if you end up accidentaly engraving the wall of your shop instead.
Bob
Re: Clamping
Posted: Thu Aug 26, 2010 5:34 pm
by wyzarddoc
Bob;
Thanks for the files!!! Just don't understand why it keeps carving out Bob was here????!!! LOL
thanks again
Re: Clamping
Posted: Thu Aug 26, 2010 7:40 pm
by Bob
Dang! I could have put that in really small print on the clamp.
Next time.