Just bought Piranha last weekend, installed Cut2D, but I'm not sure what post-processor to use? Shark post-processors are listed in the software, but not Piranha's?
Cut2D post-processor for Piranha
Moderators: al wolford, sbk, Bob, Kayvon
Cut2D post-processor for Piranha
Hi folks,
Just bought Piranha last weekend, installed Cut2D, but I'm not sure what post-processor to use? Shark post-processors are listed in the software, but not Piranha's?
Just bought Piranha last weekend, installed Cut2D, but I'm not sure what post-processor to use? Shark post-processors are listed in the software, but not Piranha's?
Re: Cut2D post-processor for Piranha
I believe the Piranha should be using the same post processors as the other Shark CNC models.
-
joethegasman
- Posts: 22
- Joined: Mon Dec 15, 2014 8:06 pm
Re: Cut2D post-processor for Piranha
yup, i took the chance and just used the shark post proc. works fine.
-
WoodEraser
- Posts: 162
- Joined: Fri Jul 20, 2012 7:07 am
Re: Cut2D post-processor for Piranha
Page 26 in your owners manual states to use one of the 2 post processors for the Shark depending on what program you are using.
Eric the "WoodEraser"
Sun City Center, Florida
If today were perfect there would be no need for tomorrow.
Sun City Center, Florida
If today were perfect there would be no need for tomorrow.