CNC Shark Forum

Posted: **Mon Jan 05, 2015 1:29 pm**

Hi folks,
Just bought Piranha last weekend, installed Cut2D, but I'm not sure what post-processor to use? Shark post-processors are listed in the software, but not Piranha's?

Posted: **Tue Jan 06, 2015 3:20 pm**

I believe the Piranha should be using the same post processors as the other Shark CNC models.

Posted: **Tue Jan 06, 2015 10:41 pm**

yup, i took the chance and just used the shark post proc. works fine.

Posted: **Wed Jan 07, 2015 2:15 pm**

Page 26 in your owners manual states to use one of the 2 post processors for the Shark depending on what program you are using.

CNC Shark Forum

Cut2D post-processor for Piranha

Cut2D post-processor for Piranha

Re: Cut2D post-processor for Piranha

Re: Cut2D post-processor for Piranha

Re: Cut2D post-processor for Piranha