Replacement collet and nut for a DWP611 router
Posted: Tue Mar 22, 2016 6:38 pm
Hi Folks,
I bought a very nice used shark and when I got it all hooked up and ready to cut I learned, sadly, that the standard collet that is sold with the DeWalt 611 is way to big for my 2mm single flute end mill bits. And then I found out the collet and nut are not separable (like it is on my old machine). So now I'm on the hunt for a new collet - does anyone have any suggestions? Is there a website that sell that stuff?
Thanx!
I bought a very nice used shark and when I got it all hooked up and ready to cut I learned, sadly, that the standard collet that is sold with the DeWalt 611 is way to big for my 2mm single flute end mill bits. And then I found out the collet and nut are not separable (like it is on my old machine). So now I'm on the hunt for a new collet - does anyone have any suggestions? Is there a website that sell that stuff?
Thanx!