Tool Spped and depth of cut
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 16
- Joined: Sat Dec 14, 2019 1:20 pm
Tool Spped and depth of cut
We are in the process of buying a Shark II to cut shapes out of poplar. 1 project is 2.25" thick and the other is .5 inch thick. Does anyone have a table with "Material Type", "Depth of Cut",Tool Path Speed"
Re: Tool Spped and depth of cut
Cal,
Start with a search of this forum for, "feed and speed" This will link you to a lot of pertinent postings.
The Vectric software now calculates chip load too.
You may not find the exact answer you want, but this will get you a bunch of information.
Bob
Start with a search of this forum for, "feed and speed" This will link you to a lot of pertinent postings.
The Vectric software now calculates chip load too.
You may not find the exact answer you want, but this will get you a bunch of information.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
-
- Posts: 16
- Joined: Sat Dec 14, 2019 1:20 pm
Re: Tool Spped and depth of cut
Bob
That was a big help. Thanks for the "tip"
Cal
That was a big help. Thanks for the "tip"
Cal