Re: Loosing depth on cuts
Posted: Sat Dec 28, 2019 4:09 pm
Tony,
It looks like you nailed it in your second post: "Is the gantry set too high? Might lower the gantry, I have mine set at the middle ones."
Gary might have misunderstood that solution.
Gary,
What are you going to do for your solution? Just lowering the bit so it sticks further out of the collet can be dangerous. Having a thicker spoilboard would be a solution. But, lowering that gantry looks best. Lowering the router/spindle in the mount could also work.
Just my thoughts,
Bob
It looks like you nailed it in your second post: "Is the gantry set too high? Might lower the gantry, I have mine set at the middle ones."
Gary might have misunderstood that solution.
Gary,
What are you going to do for your solution? Just lowering the bit so it sticks further out of the collet can be dangerous. Having a thicker spoilboard would be a solution. But, lowering that gantry looks best. Lowering the router/spindle in the mount could also work.
Just my thoughts,
Bob