HD 5 Sensor on left side of gantry?

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk

Post Reply
Sandow12
Posts: 8
Joined: Tue Dec 17, 2019 1:27 pm

HD 5 Sensor on left side of gantry?

Post by Sandow12 »

What does that little sensor do on the left side of the gantry? There is one on the gantry and one on the spindle carriage. Couldn't find anything about it in the manual.

csmithwoodworking
Posts: 10
Joined: Wed Jan 22, 2020 8:34 am
Location: Conover, NC
Contact:

Re: HD 5 Sensor on left side of gantry?

Post by csmithwoodworking »

Do you have a pic? I just got the HD5 EXT and don't see a sensor.
I'll C-N-C ya later!

Post Reply