Hello all. Brand new here as I just purchased my very first cnc. It is a very old shark "pictures below". And I need some help with a few setup things. As I said this model I believe is kinda old, I unfortunately cannot find a model number or serial number anywhere. Also I do not know what kind of software I should look at. I had to order a serial to usb cable just to connect a computer. Any help would be greatly appreciated.
Thank you
Erik
I need help
Moderators: al wolford, sbk, Bob, Kayvon
Re: I need help
Send email to support@nextwavecnc.com for control panel 2.1 to run your machine. Also you can call 419-318-4822 9AM-5PM EST Mon-Fri.
https://www.nextwavecnc.com/support
https://www.nextwavecnc.com/frequentlyaskedquestions
Tony
https://www.nextwavecnc.com/support
https://www.nextwavecnc.com/frequentlyaskedquestions
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.