Page 1 of 1
clamp down
Posted: Sun Jun 13, 2021 8:54 pm
by tamky69
any ideas how to clamp down negative y axis using full deminsions
Re: clamp down
Posted: Mon Jun 14, 2021 10:01 am
by Kayvon
I'm not sure what you're asking.
Are you trying to clamp the material down on an axis? Or change the g-code to prevent a movement direction or boundary? Is this a VCarve/Aspire question?
Re: clamp down
Posted: Mon Jun 14, 2021 5:48 pm
by tamky69
iM TRYING TO CLAMP DOWN PART OF BOARD CLOSEST TO ME WILL USING 12 INCH WIDE X AXIS AND 13 INCH Y AXIS
Re: clamp down
Posted: Tue Jun 15, 2021 6:30 am
by Bob
In order to better understand your question, I would appreciate seeing a drawing or photo of the situation.
-Bob
Re: clamp down
Posted: Tue Jun 15, 2021 1:43 pm
by Kayvon
Yes, a picture would help substantially. With what little we know here, the only answer I can offer is, "Use a clamp," which probably isn't as helpful as you wanted.