Troubleshooting - CNC Shark CP v2.1 Connected USB
Posted: Mon Jan 02, 2023 4:19 pm
“Old Dog” Forgot new tricks! Help!
I have not run this machine for almost two years do to health problems.
CNC Shark System as follows:
CNC Shark with Processor CP v2.1 connected via USB to
Dell XPS 13 w. 11th Gen i& @ 2.8 GHz 64-bit OS, x64-base processor
OS: Windows 11 – Home Addition Build: 220000.1335
Drivers Updated to current
Connected to a Dell Lighting Docking Port
External device connected to docking Port:
External Dell Monitor
External Dell Bluetooth Keyboard & Mouse
USB to CNC Shark Controller
G-Code all generated with Vectric VCarve Pro v8.5
We have successfully ran this system in the past.
I have created a couple new quick engrave programs and save them with the post processor CNCShark-USB Arcs (inch)(*.tap) When I load and start program it runs about 3-4 seconds, the spindle moves to the start position and stops.
I loaded and old (*.tap) file and it ran successfully. I’m thinking there might be and issue with the post processor file selected (CNCShark-USB Arcs (inch)(*.tap)).
All Ideas are more than welcome.
Registration Info.: Mod edit: Removed shark registration keys screenshot
Have a great day!
.... Rod
I have not run this machine for almost two years do to health problems.
CNC Shark System as follows:
CNC Shark with Processor CP v2.1 connected via USB to
Dell XPS 13 w. 11th Gen i& @ 2.8 GHz 64-bit OS, x64-base processor
OS: Windows 11 – Home Addition Build: 220000.1335
Drivers Updated to current
Connected to a Dell Lighting Docking Port
External device connected to docking Port:
External Dell Monitor
External Dell Bluetooth Keyboard & Mouse
USB to CNC Shark Controller
G-Code all generated with Vectric VCarve Pro v8.5
We have successfully ran this system in the past.
I have created a couple new quick engrave programs and save them with the post processor CNCShark-USB Arcs (inch)(*.tap) When I load and start program it runs about 3-4 seconds, the spindle moves to the start position and stops.
I loaded and old (*.tap) file and it ran successfully. I’m thinking there might be and issue with the post processor file selected (CNCShark-USB Arcs (inch)(*.tap)).
All Ideas are more than welcome.
Registration Info.: Mod edit: Removed shark registration keys screenshot
Have a great day!
.... Rod