Shark pro just stopped
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 30
- Joined: Wed Aug 25, 2010 2:51 pm
Shark pro just stopped
My shark just stopped running. Will not go in any direction. The green light on the power supply FS-20024-1M is off but when I disconnect the controller the little green light comes on and shows 24Volts with a meter but doesn't register voltage when the power supply is connected to the the controller. Any Advice. This machine has been running great for years.
Re: Shark pro just stopped
There is a fuse under the power cord. There should also be a replacement in there as well. Check the fuse.
-
- Posts: 30
- Joined: Wed Aug 25, 2010 2:51 pm
Re: Shark pro just stopped
fuse is OK, any other thoughts?
Re: Shark pro just stopped
Did you call support at nextwaveautomation? (419) 491-4520
They will help you
Tony
They will help you
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
-
- Posts: 3
- Joined: Wed May 20, 2015 4:57 pm
Re: Shark pro just stopped
they don't have everytime what you need
-
- Posts: 48
- Joined: Sun Oct 12, 2014 9:04 pm
Re: Shark pro just stopped
Hi, I have another thread on the issues I have had. I received the new controller with a new circuit board only to find (after a few days of heavy use) that the power supply is now bad (lights on, fuze's good, works for a few minutes then stops) Next wave is sending me a new one (mine is still under warranty).
While a pain, they are very responsive, just a slow process.
Tony
While a pain, they are very responsive, just a slow process.
Tony