I've been told to check to see that set screws are tightened on the coupler because in a profile toolpath my machine is drifting on the second pass. Does anyone have a pic as to what I'm looking for?
Thanks!
Coupler location on 60th Anniversary Edition
Moderators: al wolford, sbk, Bob, Kayvon
Re: Coupler location on 60th Anniversary Edition
Ack! Sorry we didn't respond sooner. Did you get this figured out? Below are three pix of the three couplers, one on each of the X, Y and Z axes:
They all take a 4mm hex wrench, though a 5/32" will work in a pinch.
The odd white specs everywhere are from the aluminum chips/flakes reflecting the phone's flash
Hope that helps, and again...my apologies for taking so long. No excuses, we should have done you better.
Thom
They all take a 4mm hex wrench, though a 5/32" will work in a pinch.
The odd white specs everywhere are from the aluminum chips/flakes reflecting the phone's flash
Hope that helps, and again...my apologies for taking so long. No excuses, we should have done you better.
Thom
=====================================================
ThomR.com Creative tools and photographic art
A proud member of the Pacific Northwest CNC Club (now on Facebook)
ThomR.com Creative tools and photographic art
A proud member of the Pacific Northwest CNC Club (now on Facebook)