CNC Shark Forum

i have been using my sd110 for a few weeks, went to use it and i am not getting any power to the controller, lights do not light up, computer say's no controller detected when connected directly to it, touch screen controller also not working when i have a thumb drive in it, any help is appreciated.

thanks

Look for a fuse in the back below the plug.

Tony

Dave,
Check the fuse that's inside the end of the power cord where it connects to the controller. There's a tiny cover where the fuse is, and a spare. Please excuse the kind of vague description, but look carefully it is either on the plug or socket.

Also check power to the shop...
Bob

Thanks, but my controller does not have a little door for a fuse.

It's a very small storage flap in the outlet. This is a miniature fuse and easy to miss.

my controller is not like the ones i have seen in the pictures, there is no little door.

Try this:
https://www.youtube.com/watch?v=qvln9VCa8AY