speed

[jjutras2]

I put this under programming but did not get any response so trying here to see if some ppl that don't read programming might have an answer for me please have a look at this link

http://www.cncsharktalk.com/viewtopic.php?f=10&t=2491

Thank you

Sylvain

[Consultingwoodworker]

I do not know about PhotoVCarve, but the feed speeds in VCarve Pro are determined by the bit you choose. When you select the tool, whatever the feed speed is in the tool file is what will output to the .tap file. What you did anywhere else will likely have no bearing on this.

You can either change the feed speed in the tool file, in which case all future uses of that tool will have the same feed, or you can use the edit button to change the feed in that project.

Ralph