not turning on?!
Moderators: al wolford, sbk, Bob, Kayvon
not turning on?!
the cnc machine is not turning on, is this a common issue, or did our not usiung a surge protector bite us in the butt?
-
- Posts: 488
- Joined: Fri Apr 08, 2011 2:14 pm
Re: not turning on?!
Open the controller box.There should be a fuse,If it is blown replace it.There are a few posts on this.radio shack has the fuse.Also check that your e stop is not pushed in.Iam sure others will chime in on this.Basecircle
Re: not turning on?!
If you look in the Shark Owner's Manual - available from the NWA Downloads page - you'll find details on the Shark Control Box fuses.
Re: not turning on?!
forgot to reply, the power cord was shot, replaced power cord and ta-da