Shark 3D newbie question
Moderators: al wolford, sbk, Bob, Kayvon
Shark 3D newbie question
I'm starting to attempt 3D with my CNC Shark. Is there a special bit that I should be getting or do I just use a v-bit or other standard bit?
Hank
*************************************
I've cut it three times and it's still too short.....
CNC Shark Slimline
*************************************
I've cut it three times and it's still too short.....
CNC Shark Slimline
Re: Shark 3D newbie question
To do 3D work you will need the following bits. .25 endmill, .25 Ball nose, .125 ball nose just to get you started. Watch the tutorials on vectric lot of info there.
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
Re: Shark 3D newbie question
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
Re: Shark 3D newbie question
Thanks for all the great info! That's exactly what I needed.......
Hank
*************************************
I've cut it three times and it's still too short.....
CNC Shark Slimline
*************************************
I've cut it three times and it's still too short.....
CNC Shark Slimline