I have been reading all the posts about upgrading a Pro to an HD, to reduce the flexing. I see rungemach posted some dxf files. When I import them to Vectric, they are tiny, like 1mm x 1mm x 1mm.
Any ideas what I am doing wrong?
Thanks in advance.
texasinmi
Turning a Pro to an HD
Moderators: al wolford, sbk, Bob, Kayvon
Re: Turning a Pro to an HD
Hello
The files were developed in inches, not mm. That is most likely the issue.
Kindest regards
Bob
The files were developed in inches, not mm. That is most likely the issue.
Kindest regards
Bob