Page 1 of 1

New Ball Screws Quetions:

Posted: Tue Jan 10, 2017 12:38 am
by Bruce Tainter
I recently replaced and upgraded my ball screws and the tread is a bit different than the originals. Now my work is running off about an eighth of an inch on X, Y, and Z. How can I compensate for this deviation?

Re: New Ball Screws Quetions:

Posted: Tue Jan 10, 2017 9:27 am
by Kayvon
You may be able to compensate for that with a custom post processor (tap) file. The control panel software also has some ability to compensate with password 787.

Re: New Ball Screws Quetions:

Posted: Tue Jan 10, 2017 6:02 pm
by tonydude
Call support at nextwaveautomation, they should tell you what the ball screw specs are. Tell them what machine you have.

Tony